Slayer Espresso 1 Group
OVERVIEW
The dream machine. Whether it’s the cornerstone of your cafe or the prize jewel in your kitchen, the Slayer Espresso Single Group is unmatched in design and innovative technologies. Fully equipped with patented needle-valve technology for ultimate flow rate control, an independent brew tank for impeccable temperature stability, a commercial group head, and an individual tank for unlimited steam capacity. Steam and pull shots simultaneously and continuously without pressure drops or temperature loss. You’ll have all the necessary tools to extract the best flavors from each coffee over and over again. This machine was built for commercial use, but fits right in at home, too.
FEATURES
Patented needle valve for restricted flow rate aka Pre-Brew
Independent brew and steam tanks
PID temperature control, adjustable in 0.1° increments
SSR circuit board for added efficiency and temperature stability
Electronic V3 grouphead rated to 1 million cycles
Commercial brew group assembly and portafilter with 58mm, 18-gram basket
Nanotech-coated precision shower screens
Handcrafted with wood handles and actuators
Internal rotary vane pump
Lifetime/resettable shot counter
Power switch for easy on/off
Shot mirror
Hot water tap
**All prices are subject to change without prior notice due to currency fluctuation, fuel prices and/or unforeseen economic circumstances
Technical Information
LENGTH
Body: 46.0 centimeters
Foot to foot: 45.0 centimeters
WIDTH
Body: 61.7 centimeters
Foot to foot: 44.4 centimeters
Rear panel (top) to disengaged steam actuator (top): 28.5 centimeters
HEIGHT
Top of rear panel: 323.8 millimeters
Top of brew actuator: 340.3 millimeters
Top of engaged steam actuator: 368.3 millimeters
Group height, drip tray to portafilter: 119.4 millimeters
WEIGHT
Dry: 45.5 kilograms
Wet: 49.9 kilograms
Shipping: 72.60 kilograms
GENERAL SPECIFICATIONS
Tank CapacitiesBrew tank: 1.1 liters
Steam tank: 3.3 liters
Pre-heat coil: 60.0 milliliters
Power & Electric: 220 volts / 10 amps
600-watt brew tank heating element, 2,000-watt steam tank element for 220-volt option
Minimum load capacity: 70.0 kilograms
Hole for power/water/ drain: 5.0 centimeters
PLUMBING
Water line: dedicated 3/8-inch British Standard Pipe (BSP), cold with shut-off valve*
Incoming water pressure: 3-5 Bar
Drain: open gravity drain located within 1.2 meters
Included accessories: 5/8-inch / 15.88-millimeter drain hose with hose clamp AND 60-inch x 3/8-inch / 152.4-centimeter x 9.53-millimeter braided steel hose
WATER TREATMENT
Hardness: not to exceed 50 parts-per-million
Total dissolved solids: 75-125 parts-per-million